DIY Q&A:Cork might work well for kitchen flooring

November 23, 2012 

Q: We want to install flooring in our kitchen and bathroom that is resistant to slipping when wet, but also easy to clean. – L. Sharp

Most floors that are slip-resistant are not easy to clean. Most so-called anti-skid flooring has a coarse or textured finish, which gives better traction but also collects more dirt that can’t easily be wiped off.

Many types of anti-slip flooring, such as special ceramic tiles and plastic laminates, are designed for commercial use. There are also special coatings for slippery floors, but most contain grit to improve traction.

One less-slippery flooring choice that might go well in a kitchen is cork, which some manufacturers say is easy to keep clean. Visit gerbertltd.com and click on Cork Flooring.

Many homeowners opt to use vinyl or smooth ceramic tiles, and help avoid slipping by using nonskid rugs or mats in traffic areas and at showers and bathtubs. Throw rugs and mats are available at most department stores; they have foam backs that resist sliding. Choose mats that can be tossed into the washing machine when they get dirty. When it’s time to clean the floor, simply pick up the mats and proceed.

Repairing pitted sink

Q: The bowl of our bathroom sink is somewhat pitted and I’m looking for the best approach to repairing it. Is epoxy spray paint the best way to go? – J. Higgins

Aerosol spray paint is a great innovation, but my choice to refinish the sink is a two-part epoxy paint applied with a brush. Be aware that painting might make the pits less visible but won’t eliminate them.

There are products available to fill chips, but getting one to adhere in small pits and end with a smooth surface won’t be easy.

If you go ahead with painting and choose a spray, you will have to very carefully mask surrounding surfaces to keep paint from going where you don’t want it. The aerosol sprayer will apply only a very thin coat at a time, and it takes great care and some practice to get an even finish.

Two-part epoxy in a can, applied with a brush, is much easier to control and you’ll get a thicker, tougher finish.

That said, I should add that painting bathroom fixtures often isn’t a good choice for do-it-yourselfers. The surface must be very carefully cleaned and prepared or the finish won’t adhere for long – peeling and chipping are common problems.

You can get a professional to refinish the sink (check Bathtub Repairs and Refinishing in your yellow pages), but even a pro job should be considered only temporary, probably with a lifespan of no more than five years.

If the sink is in such poor condition that it bothers you, I think the best bet is to replace it. Unlike bathtubs, sinks are relatively inexpensive and usually need only some easy-to-make plumbing connections.

Affixing laminate edging

Q: A piece of plastic-laminate edge banding about 8 inches long has come loose from my kitchen counter top. How do I fix it? – Henry

Good choices are Liquid Nails or Goop, both of which are sold in toothpaste-type tubes at many home centers. Sand the back of the loose banding and the counter edge lightly with fine sandpaper to remove some of the old adhesive. Spread a thin film of adhesive on the counter edge and press the banding into place. Hold it in position with strips of duct tape until the adhesive sets.

McClatchy-Tribune News Service

Austin: gaus17@aol.com

News & Observer is pleased to provide this opportunity to share information, experiences and observations about what's in the news. Some of the comments may be reprinted elsewhere in the site or in the newspaper. We encourage lively, open debate on the issues of the day, and ask that you refrain from profanity, hate speech, personal comments and remarks that are off point. Thank you for taking the time to offer your thoughts.

Commenting FAQs | Terms of Service