Handyman

Handyman: Which first – staining or painting?

Boston GlobeMay 16, 2014 

Q: New doorway with new casing and new skim coat on the wall. Should I stain casing (walnut) first or paint (light green) wall first?

A: Do the casing first because it is easier to stain the edges of the casing without getting any on the wall. Also, if you get stain on the wall, the paint will cover it.

Fireplace problems

Q: I have two fireplaces in my Colonial-style house: one on the first floor, the other in the basement. Whenever I have a fire on the first floor, I get smoke in the basement. How can I correct that?

A: There may be a difference in air pressure between the first floor and basement, and smoke from the first-floor fireplace is going up the chimney and down to the basement. Try this: Add more combustion air to the first-floor fireplace room; open a window opposite the fireplace. There are other ways to fix it, but call a fireplace expert to help you.

Leave the paneling

Q: Some of the walls in my house are wallpapered over a lining material that runs horizontally over the imitation paneling of the 1970s. It was put on by a professional paper hanger who did good work, so the walls were properly prepared. After pulling up a small section of the paper, I can feel the residue paste on the lining. I would like to paint the walls. Can I clean the old paste from the lining? The paper in one room is textured and heavy, so I don’t think painting on top of the paper will be good. So far, the advice given to me is to take down the paneling, but I’m too old for that!

A: I don’t think that advice was very good. Yes, you can paint the walls. For the spot where you felt the paste residue, reapply the liner. Apply one coat of a latex interior primer and finish off with latex wall paint. The same goes for the heavy textured paper in another room. I have painted both vinyl-coated paper and heavy vinyl material with great success. Mainly, keep every coat as thin as possible

Heavy foundation work

Q: We have a house built in 1925 that has a granite-block foundation. We are getting a leak in one corner when it rains, and it appears that the mortar or cement between the stones is the source. There is a gutter above that corner, and I have tried to divert water away from the house. Any suggestions on how to repair this situation without digging a trench and installing a pump?

A: I think water is coming through those degraded joints between the blocks. Keeping water away via gutters is also good. To fill those places that have lost mortar, you can repoint, chipping out old mortar and pressing in new. A mason can do this, but you can, too; just be aware that it is heavy work. If it is successful and stops leaks above the floor, then you can tackle ground water that is coming up between the floor slab and block wall.

Hotton: photton@globe.com

News & Observer is pleased to provide this opportunity to share information, experiences and observations about what's in the news. Some of the comments may be reprinted elsewhere in the site or in the newspaper. We encourage lively, open debate on the issues of the day, and ask that you refrain from profanity, hate speech, personal comments and remarks that are off point. Thank you for taking the time to offer your thoughts.

Commenting FAQs | Terms of Service