Q: A squirrel or several squirrels ate a hole in my lead flashing, and now it leaks badly when it rains. Water from the roof runs down into the hole. The top of the flashing is cemented into the chimney between the bricks. The job has lasted many years. The hole is about the size of a squirrels head. How can I repair it?
A: Buy a heavy-duty piece of sheet aluminum or galvanized steel big enough to cover the hole and surrounding area. Lead flashing around chimneys is usually not glued to the roof, so lift it carefully, slather the roof and patch with roofing cement, and insert the patch under the flashing. If the flashing is glued to the roof, you can put the patch directly on top, then keep an eye on it to see how long it lasts. Finally, treat the patch with a critter repellent, sold in hardware stores.
Beware of septic gas
Q: I renovated a split-level ranch last year. I am getting septic odors downstairs in my house quite frequently, especially after a family member has showered. Odors seem to be coming from the laundry room where the vent stack is in the house. Im not sure whats causing the problem. Any ideas on what I can do to fix it?
A: It sounds as if the vent stack is blocked or unconnected to the shower room and other places. The vent stack takes septic fumes up through the roof, where they are released. An unvented shower, toilet, or any other appliance can be dangerous. Have a plumber check it out and clear the stack. Dont wait; septic gases can be lethal.
Sealing a crack in door
Q: My wooden front door has developed a long crack wide enough to see light through it. Can it be sealed with plastic wood or wood filler, or should some other method be taken to save the door?
A: The crack must be in one of the panels, which are thinner than the frame pieces. This was caused by expansion and contraction of the wood. Try this: Buy adhesive caulk that will firm up as hard as plastic wood or wood filler. Fill the crack with this caulk, pressing it in with your fingers. Hold a board on the other side to keep the caulk from oozing through. Let it set. You can scrape it smooth. Do the other side if necessary. Finally, paint the panel to match the door.
Get old ductwork cleaned
Q: We have a forced hot air heating and air-conditioning system. I see ads all the time for air-duct cleaning. My heating, ventilation, and air-conditioning company doesnt do it, and they have said that such cleaning can damage the ducts. Do you have an opinion?
A: If your ductwork is more than 25 years old, its a good idea to have it cleaned. Sure, damage can occur, but its rare and reputable companies will fix it. My own ducts are 50 years old, and they were stuffed with dirt, crud, and you name it. I had them cleaned, and theyll be good for another 25 years or so. Do it!
Keeping bees out
Q: While cleaning gutters recently, I saw what appeared to be many bumblebees going in and out of space on the fascia, possibly into the attic area. I believe these were some type of bumblebee, but I could be wrong. I sprayed insecticide, but what now? Should I caulk the hole or fill it with expanding insulating foam?
A: Dont use insecticides. Bees are beneficial because they are pollinators. Fill the holes with adhesive caulk and/or replace the damaged wood.