A building that once hummed with the whir of more than 100 people operating 10,000 spindles now lies dormant, a relic of a time when cotton was king and trains were the lifeblood of Southern commerce.
More than a century old, the 55,000-square-foot Clayton Spinning Mill closed in 1976. Its faded brick facade shows its age, but its owners believe it has some life in it yet.
They hope to turn the building and the surrounding land into a sports and retail complex with the help of the state mill-rehabilitation tax credit they were awarded earlier this year. The credit will offset the cost of renovating the historic structure.
“You can’t do a project like this without the tax credits unless you’re walking around with $10 million in your pocket,” said Michael Hubbard, who owns the mill with fellow Clayton resident Steve Yauch.
Never miss a local story.
The mill credit will expire at the end of the year for properties that haven’t been approved to receive it. With about a month left to apply for eligibility, dozens of developers are scrambling to get approval for rehabilitation projects like the Clayton mill, massive undertakings that often can’t be completed without the state incentive.
Tim Simmons, federal rehabilitation tax credit coordinator and senior preservation architect at the State Historic Preservation Office, said the number of applications submitted this year began to rise during the summer.
“I know that this year, mill projects are up,” he said.
The mill credit is one of three historic-preservation tax credits that the state legislature chose not to renew this year. The 20 to 30 percent credits for residential and commercial properties will expire Jan. 1, while the 30 to 40 percent credit for mills will expire only for projects that haven’t received state approval before year’s end.
Enacted in 2006, the mill credit can be used in addition to the 20-percent federal tax credit for the rehabilitation of properties on the National Register of Historic Places. To date, the incentive has aided in the completion of 28 mill projects – more than half of them in Durham and Winston-Salem – and 43 more have been proposed in counties across the state.
But not all potential projects will be deemed eligible before the deadline. Myrick Howard, president of Preservation North Carolina, said any mills not yet listed on the National Register might not receive the credit because the listing process usually takes about a year to complete.
“These projects are going to be really hard to do without any tax credits, and there is a good chance we’re going to see mills like that being deconstructed for materials,” he said. “That’s taking an economic development opportunity and taking it apart and throwing it away.”
On Nov. 21, the N.C. Department of Cultural Resources announced that 17 properties in the state had been added to the National Register.
The decision not to renew the historic-preservation program aligns with the goals of the 2013 Republican overhaul of the state tax code, which reduced income tax rates for individuals and businesses and eliminated some tax credits. Between 2006 and 2012, mill-rehabilitation projects qualified for about $128 million in credits, according to State Historic Preservation Office data. The tax credits for commercial and residential properties, available since 1998, have cost the state more than $230 million since their inception.
In his 2015 budget proposal, Gov. Pat McCrory included a less expensive version of the historic-preservation program that reduced tax-credit percentages and capped eligible rehabilitation expenditures at $20 million. The modified program would reduce its cost to the state by $10 million to $15 million annually, according to State Historic Preservation Office data.
The House supported the less expensive program, but the Senate did not. Sen. Bob Rucho, co-chairman of the Senate Finance Committee, did not respond to several requests for comment.
“Tax credits are not an acceptable part of tax reform, so it hit a wall in the Senate,” said Howard, the Preservation North Carolina president.
He said he expects the legislature will consider implementing a version of the tax credit or an alternative incentive next year.
Proponents of the preservation program argue the economic benefit of rehabilitating historic mills far exceeds the initial cost to the state. The 28 mills rehabilitated with the help of the tax credit cost a total of $563 million to complete, and each supplies more jobs and tax revenue than it did before its renovation.
Though less extensive than many projects completed with the use of the tax credit, rehabilitation of the Clayton mill will cost $3 million to $5 million. The building’s 150 arched windows are bricked over, and restoring their original design could cost as much as $7,500 per window, Hubbard said.
Hubbard is looking to use both a 30-percent state mill credit and a 20-percent federal credit. If the project ends up costing $3 million, Hubbard estimates it could qualify for about $1 million in tax credits. While North Carolina buildings that are later added to the National Register will be able to apply for federal credits in the future, those often aren’t enough to make a project economically viable.
Renovating the Clayton mill without retaining as much of the original architecture would cost less and might not require the mill credit to complete. But Hubbard said he and and his team opted to preserve the integrity of a small-town fixture, a goal that resonates with some Clayton residents.
“When you find a new purpose for older buildings, you’re saving the history,” said Pam Baumgartner, historian at the Clayton library and a longtime resident. “Cotton was one of the first big industries here, and (the mill) really did have a big impact.”
Construction is expected to begin next year. Hubbard said he hopes the development will fill a need in Clayton, a town of nearly 18,000 whose population has increased by a third during the last decade.
“Clayton has boomed in its own right, and for the most part it’s starting to burst at the seams,” he said. “That’s why we’re looking at this project. It can be a destination for the town.”